Rear Mount Fold-Up Tub Bench Seat by Seachrome | 29" x 16.5" | One Piece Frameless Phenolic Teak | STR-290165 PTS
A sleek, rear-hung tub seat that folds down to rest on the ledge of a tub. It is made from durable, one-piece frameless phenolic material with smooth, rounded edges, on a #304 stainless steel bracket, to provide secure support.
- Model # STR-290165
- Seat top: made from solid phenolic material, offered in Almond, Teak or White
- Seat top design: One-piece solid with standard drain slots
- Mounting bracket: #304 stainless steel (10 gauge, .135), welded to stainless steel tubing (1" round x 18 gauge, .048)
- Seat automatically held in place (when raised up) by friction hinge bracket
- Available size: 29"W x 16-1/2"D
- Meets and exceeds the minimum 250 lb. load requirement when properly installed
| STANDARD SEAT MATERIALS/COLORS |
|
Phenolic – White, Almond or Teak, 1/2” (13mm) thick x 3” (76mm) wide slats bolted to frame with countersunk stainless steel screws. |
| SPECIFICATIONS |
|
Seachrome seats meet Federal Spec. WW-P-541/8B and ANSI 117.1. When properly installed, all seats exceed applicable federal load specifications. These models have been independently tested to withstand 1,000 lbs in a 30-minute static load test. NOTE: Seachrome recommends that all accessibility seats, as well as grab bars, be installed using 2” minimum thickness “in-wall” solid wood backing material with #10 x 2” stainless steel, Phillips head, sheet metal screws, or using a wall-imbedded minimum 12 gauge (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Load Bearing and Installation:When properly installed, all Seachrome shower seats have been designed and manufactured to support loads exceeding the downward pull requirements for Federal specifications FHA, VA, HUD, hospital codes, and private construction. The actual "in use" load bearing capacity of any shower seat, however, will be limited by the strength of its mounting surface and installation hardware. Seachrome recommends that shower seats be installed using 2" minimum thickness "in wall" solid wood backing material with #10 x 2" stainless steel, phillips-head, sheet metal screws, or using a wall embedded, minimum 12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Please contact the factory for further mounting recommendations. Under no circumstances should any shower seat be mounted to drywall, sheetrock, plaster, fiberglass, acrylic or other similar "hollow" wall surfaces without appropriate wood or steel backing material. Specifications Seachrome STR-290165 - Spec Sheet Brochure https://seachrome.com/file_downloads/signature_brochure_web.pdf |
