Bench Style 18" x 15" Shower Seat by Seachrome | Swing Down Legs | Naugahyde SSB2-180150
A convenient bench seat that provides secure support in the shower, and easily folds against the wall when not in use. It features swing-down legs that raise the seat to the 17-19" minimum height required to meet ADA regulations. Choose from a range of material and finish options.
Signature series products are made from #304 stainless steel, phenolic white, teak, HDPE, padded naugahyde and solid-surface materials. The Signature product line incorporates Seachrome’s expertise in ADA guidelines, to ensure safety and compliance over longterm use. We use recycled materials whenever possible, to ensure that finished products are LEED compliant. Signature series grab bars and accessibility seats are WingIts compatible. Signature series products are proudly made in the USA.
|
|
| STANDARD SEAT MATERIALS/COLORS |
|
Naugahyde (Standard) – White or Almond, covering 2” (51mm) thick foam mounted on 1/2” (13mm) thick marine plywood. Phenolic – White or Teak, 1/2” (13mm) thick x 3” (76mm) wide slats bolted to frame with countersunk stainless steel screws. Phenolic Solid – White or Teak, solid 1/2” thick single seat top with slots for drainage. HDPE (High Density Polyethylene) – White, 1/2” thick one piece. Solid Surface – Various Colors, 1/2” thick solid surface material. |
| SPECIFICATIONS |
|
Load Bearing and Installation: When properly installed, all Seachrome shower seats have been designed and manufactured to support loads exceeding the downward pull requirements for Federal specifications FHA, VA, HUD, hospital codes, and private construction. The actual "in use" load bearing capacity of any shower seat, however, will be limited by the strength of its mounting surface and installation hardware. Seachrome recommends that shower seats be installed using 2" minimum thickness "in wall" solid wood backing material with #10 x 2" stainless steel, phillips-head, sheet metal screws, or using a wall embedded, minimum 12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Please contact the factory for further mounting recommendations. Seachrome seats meet Federal Spec. WW-P-541/8B and ANSI 117.1. When properly installed, all seats exceed applicable federal load specifications. These models have been independently tested to withstand 1,000 lbs in a 30-minute static load test. NOTE: Seachrome recommends that all accessibility seats, as well as grab bars, be installed using 2” minimum thickness “in-wall” solid wood backing material with #10 x 2” stainless steel, Phillips head, sheet metal screws, or using a wall-imbedded minimum 12 gauge (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Click on Information Sheets below Specifications: https://seachrome.com/file_downloads/SSB2-180150-HW.pdf Product Sheet / Brochure https://seachrome.com/file_downloads/SE_Brochure_prod_f_web.pdf |
