Seachrome 36" x 18" Bariatric Shower Transfer Seat Teak or Phenolic Swing Down Legs SSB3-360180.
Designed specifically for bariatric needs, this seat’s wall-mounted frame has 3" padded stainless steel leveling feet. Seachrome Institutional, Bariatric and Stationary Bench Seats have been tested to withstand over 1,200 lbs. of force when properly installed. Solid phenolic seat top is slotted for drainage. Also available in phenolic teak.
| STANDARD SEAT MATERIALS/COLORS |
|
Phenolic – White or Teak, 1/2” (13mm) thick x 3” (76mm) wide slats bolted to frame with countersunk stainless steel screws. |
| SPECIFICATIONS |
|
When properly installed, all Seachrome shower seats have been designed and manufactured to support loads exceeding the downward pull requirements for Federal specifications FHA, VA, HUD, hospital codes, and private construction. The actual "in use" load bearing capacity of any shower seat, however, will be limited by the strength of its mounting surface and installation hardware. Seachrome recommends that shower seats be installed using 2" minimum thickness "in wall" solid wood backing material with #10 x 2" stainless steel, phillips-head, sheet metal screws, or using a wall embedded, minimum 12 ga. (2.8mm) steel anchor plate with #10 x 24 stainless steel machine screws. Please contact the factory for further mounting recommendations. Under no circumstances should any shower seat be mounted to drywall, sheetrock, plaster, fiberglass, acrylic or other similar "hollow" wall surfaces without appropriate wood or steel backing material. |
